https://board.moparts.org/ubbthreads/show...rue#Post5344236

From this previous thread, John Kunkel thinks I have an issue with the Belleville spring (Piston spring in ATSG manual.
Driving forward in Neutral and no Reverse is caused by a rear clutch that's not releasing, most common cause is a failed Belleville spring.

I have the trans out and disassymbled.

I can't remove the input shaft, rear clutch assymble from the Driving shell, Planetary gear train.

The ATSG mentions nothing about the seperation, and my 727 video shows them just coming apart.

~6" down the input shaft, there is a bearing surface and just below that is a ~snap/ round ring in a grove that has a dog leg on it. For the life of me I can't get it out. So I gave up and posted

Could it be that as John K stated, the rear clutch is hanging up and will not it allow it to seperate? With the output shaft in a hole in my bench, as I spin the driving shell, the rear clutch rotates in the opposite direction.....you can hear a slight drag of something in there.

Any ideas appreciated. Thanks