|
|
Re: Distributor wires-pos/neg
[Re: FrankenScamp]
#370906
07/09/09 04:24 PM
07/09/09 04:24 PM
|
Joined: Oct 2003
Posts: 21,345
Marysville, O-H-I-O
70Cuda383
OP
Too Many Posts
|
OP
Too Many Posts
Joined: Oct 2003
Posts: 21,345
Marysville, O-H-I-O
|
Quote:
call 'em...they've helped me. good luck!
I think that's what I'm gonna have to do. the problem I'm running into is the wire diagram that MSD provides, shows a black and orange wire from the factory distributor. the buchillion pictured above shows black and red. the distributor that I have is black and grey. it's probably a safe bet that in this case, black = black, and orange/red = grey...but then again... 
another similar question, since I'm new to MSD ignitions...where do I put the magical "rev limiter chip"? I don't see anywhere to plug one in, and no where in the diagrams or literature does it say how or where to install the rev limiter chip.
not that I absolutely need one, but might as well put one in for insurance. my dyno graph shows that I have no reason to spin this motor faster than 6200 rpm so I might as well toss in a 6200 chip incase I miss a shift or get stupid with it.
**Photobucket sucks**
|
|
|
|
|
|
|
