Slow progress. I have ordered a VR (Echlin from NAPA) and should be here tomorrow. Still working on the splice issue.

I checked the 4 pin ballast. I found that the 5 ohm resistance pins are on the bottom and the 1.5 resistance pins are on the top. Does that make any difference with the wiring and in the start / run operation?

Thanks.

Additional note. I have a 4 pin ECU and a 4 pin ballast resistor. I can find wiring diagrams for a 4 pin ECU and a 2 pin ballast or for a 5 pin ECU and a 4 pin ballast. But nothing for what I have. Does anyone know where I can find a wiring diagram for my setup?

BTW I no longer get a bump when I release the starter.