Originally Posted by Cab_Burge
Originally Posted by moparx
Originally Posted by JohnRR
I use regular old Hi temp wheel bearing grease in a grease gun tube , use an injector tip to fill it after putting it on the axle. I use a bearing heater to install them so I do it after it cools.




as above. ^^^^^^^^^^^^^^^^^^^^^^^ iagree
beer

Me three wrench up I use one of my old hand pump grease guns with a needle tip on it to inject the black high temp moly base bearing grease into the slots between the big end of roller bearings until it comes out the small ends wrench scope up
I hadn't thought about using my old manual mechanical wheel bearing grease packer, I will now wrench bow up


Exactly what I've always done.