Reusing same cam from Bullet, but I've read it's not the best choice? I'm happy with it however, and very pleased with their service. This was a premeasured sketch, the actual NET is about .735" Used the PAC 1225 spring with about .07 from C/B and intakes are 2.25" Ti. Exh 1.81 SS I had it installed at 105.5ICL but it's now installed at 107. P-2-V is still pretty far away .140/I and .200/E if i recall correctly. Nothing fancy commonly available for rings so it got 1/16 1/16 and 3/16 but i set the oil around 12lbs. Motor bars over about 15ft lbs no seals, until you bolt it all together. Run ready WITHOUT spark plugs, it's about 75ft lbs!!!