pulley install (too much interference?) UPDATE

Print Thread

Re: pulley install (too much interference?) [Re: BDW] #3014934 02/13/22 09:59 AM 02/13/22 09:59 AM
Joined: May 2005 Posts: 4,727 Florida BDW OP master
BDW OP master Joined: May 2005 Posts: 4,727 Florida	Cleaned off most of the powder coating with a Dremel tool and gave it another go. Inside diameter interference is now ~0.004” It was a mutha to pull on, but it’s done. Appreciate the help Last edited by BDW; 02/13/22 10:01 AM.

Entire Thread
Subject	Posted By	Posted
pulley install (too much interference?) UPDATE	BDW	02/10/22 10:03 PM
Re: pulley install (too much interference?)	NITROUSN	02/11/22 01:45 AM
Re: pulley install (too much interference?)	BDW	02/11/22 01:59 AM
Re: pulley install (too much interference?)	Chargerfan68	02/11/22 02:38 AM
Re: pulley install (too much interference?)	wingman	02/11/22 04:09 PM
Re: pulley install (too much interference?)	moparx	02/11/22 06:31 PM
Re: pulley install (too much interference?)	BDW	02/11/22 06:45 PM
Re: pulley install (too much interference?)	BDW	02/13/22 01:59 PM
Re: pulley install (too much interference?)	TJP	02/14/22 02:10 AM
Re: pulley install (too much interference?)	poorboy	02/14/22 02:42 AM
Re: pulley install (too much interference?)	1969ronnie	02/14/22 05:11 AM
Re: pulley install (too much interference?)	Tie Rod Garage	02/14/22 03:37 PM
Re: pulley install (too much interference?)	BDW	02/14/22 11:58 PM
Re: pulley install (too much interference?)	JohnRR	02/15/22 09:45 PM
Re: pulley install (too much interference?)	NITROUSN	02/11/22 03:05 AM
Re: pulley install (too much interference?)	BDW	02/11/22 03:14 AM
Re: pulley install (too much interference?)	BDW	02/11/22 03:18 AM
Re: pulley install (too much interference?)	NITROUSN	02/11/22 03:34 AM
Re: pulley install (too much interference?) UPDATE	RapidRobert	02/13/22 02:42 PM
Re: pulley install (too much interference?) UPDATE	Chargerfan68	02/13/22 04:10 PM
Re: pulley install (too much interference?) UPDATE	moparx	02/13/22 04:42 PM

Hop To