Finished getting the head off. Felpro 1104 gasket looks fine. Head surface has minute machining groove where the block is a lot smoother. Hot oil has to be wicking out from the return passage. I think a new gasket and some sealant on both sides of the gaskets in these areas and I should be ok.
I had the same type leeking on my MP block and MP aluminum head engine. I think you have the right idea coating the new gaskets.
I just wanted to add that I used these gaskets from Arruzza on mine and it solved the problem. I don't know if they are still available, and the bore sizes are limited to .070" over 4.250".
http://www.arruzzahighperformance.com/Parts/Parts.htmlMark
