For those interested, I got my Airwolf/ Bloomer combo going after a few years of gathering parts!
The engine was built by Marcus Giobbi at Bullet Race Engineering in Adelaide, South Australia. They do a lot of high-end billet stuff so in comparison to all that, my engine is a bit agricultural.
After all this time and effort, I've got to say I'm pretty happy with it, and the engine builder was really impressed with the quality of the heads and the crank.
The only real issue we had was with valvetrain geometry, and associated spring to rocker clearance, but that was fixed pretty easily.
Anyway, long story short - combo is as follows;
360 +.040 Bloomer 4.25 crank with 11.7 comp 98 Octane fuel Air Wolf heads Solid Roller Cam - 257 duration @ .050 .645 lift 1050 Quick Fuel 4150 Carb
Dyno'd at 625hp @ 6100 with peak 597ft/lbs of torque at 5100.
Torque was 580 from 4200
Really happy with the results and the whole process so far.
Just got to get it in a car now and get to the track!
All the best to everyone! I hope this gives you all some inspiration!
