8 3/4 to a Dana - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech 8 3/4 to a Dana

Print Thread

Re: 8 3/4 to a Dana [Re: an8sec70cuda] #2744621 02/19/20 02:26 PM 02/19/20 02:26 PM
Joined: Jan 2003 Posts: 25,951 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 25,951 Rio Linda, CA	Originally Posted by an8sec70cuda If rear ends are installed in the same location your drive shaft will have to be shorten. Quote Somewhere around an inch if I recall correctly. 1 1/8" to be exact Centerline of Axle Shaft to Center of Universal Yoke 8 3/4" 12.35" 9 3/4" 13.47" The INTERNET, the MISinformation superhighway

Entire Thread
Subject	Posted By	Posted
8 3/4 to a Dana	Stroker Scamp	02/19/20 05:51 AM
Re: 8 3/4 to a Dana	CSK	02/19/20 06:13 AM
Re: 8 3/4 to a Dana	DusterKid	02/19/20 12:21 PM
Re: 8 3/4 to a Dana	an8sec70cuda	02/19/20 01:09 PM
Re: 8 3/4 to a Dana	John_Kunkel	02/19/20 06:26 PM
Re: 8 3/4 to a Dana	an8sec70cuda	02/20/20 12:53 PM
Re: 8 3/4 to a Dana	DoctorDiff	02/22/20 05:05 AM
Re: 8 3/4 to a Dana	J_BODY	02/22/20 02:33 PM
Re: 8 3/4 to a Dana	polyspheric	02/19/20 01:41 PM
Re: 8 3/4 to a Dana	hemi-itis	02/19/20 02:16 PM
Re: 8 3/4 to a Dana	340Cuda	02/19/20 02:19 PM
Re: 8 3/4 to a Dana	polyspheric	02/19/20 05:10 PM
Re: 8 3/4 to a Dana	MadMopars	02/19/20 05:28 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1