Originally Posted By fuelishnsilly
What would have been already assembled? I'm guessing doors, fenders, hood, trunk lid were all attached already?


Yes. Body shell plus everything that is body color, as carefully noted during disassembly, such as the following list that is correct for a '69 A body and may not be correct for a GTX. But this list will give you an idea what to look for.

Body shell, partially
Upper rear shock mounting studs
Side marker housings, 4
Hood, all over
Hood Hinges, partially, and fasteners
Hood Striker and fasteners, all over
Front Fenders (except wheel well) and fasteners, exterior only
Fender tag, all over, and one screw
Yoke Cross member and fasteners, partial
Hood Lock Vertical Support and fasteners, partial
Upper Grille Panel and fasteners, exterior only
Lower Grille Panel and fasteners, exterior only
Battery Tray, Battery Tray Brace, and fasteners
Doors, except interior of weatherstripping.
Door Hinges and fasteners, partial
Deck Lid, all over
Deck Lid Hinges.
Deck Lid Hinge Supports (welded to body), partially
Deck Lid Torsion Bars, partially

Other paint: doors interior of weatherstripping, called UDF (upper door frame) color and LDF (lower door frame) color, door frame plastic plugs, and also quarter panel interior; door lock knobs; roof rails; A pillar plastic covers; quarter panel lower garnish.

In addition there are some special things to note about sealers in the engine compartment at the cowl and on fenders as noted in the photos.

Body paint notes. Fender, battery tray..jpgBody paint notes. 4 putty blobs at cowl pinch weld..jpgBody paint notes. Putty blobs at front corners...jpgBody paint notes. Sealant ooze at cowl pinch weld..jpg

If you don't see two dolphins, you need a vacation.