I have no idea who deleted that post.
Also, I have no problem admitting that I didn’t test fit the shafts onto the heads......... but I won’t let that slip by again.
Like I said previously, my only defense is I’ve never come across that particular problem before.
I’m not sure what you’re planning on to remedy it, but I think some spacers from B3RE might be the least hassle.
No probs Dwayne, all good.
I'm of the opinion now that these have not been cut as semi circular. I think they have a radius at each end with a slight flat section in the center. If this was one machine doing this and it ran for a week of so before it was detected , then these will pop up here and there. Some may very well be running on engines as we speak, undetected.
I'm thinking, mill the stands off and Max Wedge them.
