Quote:

The thing is I could swap heads with a set of ported/polished 452 from another project that are milled to 73cc. But that means milling my intake or getting another one....more$$$$.
Thanks again Rich




You could always have the intake surface of the head milled back to the correct angle. I forget what the rule of the rule of thumb is, how much to take off the intake side of the head for how much you take off the chamber side. Someone else can help you with that. Then you can run any intake you want on it without modification.

look here:
https://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=5035285

Last edited by Triple Threat; 02/18/09 07:05 PM.

-Dustin
67 Dart, 9 second, 392" G3 Hemi
68 Barracuda 340 F/SA