Quote: dizuster and I think alike. No way you can start from Penny one and build a 10.0 small block for the same cost as a BB, especially if you are running a b-body. And like he also mentions SB tend to need more gear, RPM and converter than BB, making them less drivable. The only SB I'd consider using in a B-Body would be a boosted Gen III Hemi....and I'm seriously looking at that route. Of course I'll have to break this 440 1st.
For an honest 6-8k, you can buy a r5/p7 motor that will easily run mid 9's in a typical A body. Buddy of mine did just that, except his motor was on the low side of the above range, and was going 9.40's with it in a 68 Dart within a couple of outings.
Sure but you can do it easier w/ a 400 block, 440 crank, and chevy rods. Buddy's old valaint even had leaf springs and went mid 9's. Doubt the engine saw anything above 6500.
