Quote:

Quote:

I wonder if Dayclona had to trim the molding to get it to fit?? Interesting...



When I talked with him about it, he said that he didn't have to modify the hood or the trim. Tight fit, but it went right on.

I happened to have an ASC&P reproduction hood & original rear hood trim laying around back then, so I checked the fit myself. It's real close to fitting on the reproduction hood, but won't quite go without thinning the repro hood in just a couple spots.

Tav



Going through a bunch of N94 threads & found one by "DAYCLONA" where he states his '71 T/A clone had a repro hood & trimming was needed.

Quote:

I used the stock steel 1970 hood trim, with the standard length studs/nuts,.....no trimming was needed on my hood, except where I added the rear edge SE/belt trim, that just needed a thinning of the glass for the trim to snap on, but my hood is a Fiberglass Trends repro, a very nice/accurate repro that I installed around 1980


Mike



T/A hoods on '71 Challengers