Quote:

Quote:

Quote:

Quote:

Quote:

My 8 inch glasstek




Is your scoop sealed... where is the seal at in relation
to the hood itself... also where are the carbs in the
scoop... how far from the top of the carbs to the scoop





Carbs are pretty much center of scoop and the front carb is about 3 inches from scoop, rear carb a little more clearance. There is about an inch and half clearance to windshield and carbs are not sealed to hood.




So does it run quicker sealed to the hood or not sealed?




I had a smaller cowl hood with a single carb and sealed it to hood and didn't make a bit of difference, now with the tunnel ram and two 4's i didn't mess with trying to seal the carbs on this hood.




Can you run air cleaners with that scoop? i mean is there enough room for them? i am building a 73 duster and am going to have to find a 7-8 inch tall hood scoop for my car.I am also running a tunnel-ram on RB 440. could you post a pic of the scoop from the drivers seat? if not no big deal/ thanks mopar65


3520 pound race ready 1973 Street/Strip Dodge Dart - Stock stroke 440/727 10.49 @ 125.0 on 93 pump gas & ET Street Radials. More to come... ( SGT Miller) Proudly served 12 years in the US ARMY RESERVES support our troops