Brazing an exhaust port on an iron head

Print Thread

Re: Brazing an exhaust port on an iron head [Re: POS Dakota] #1056754 08/19/11 06:06 PM 08/19/11 06:06 PM
Joined: Nov 2003 Posts: 5,160 Texas dannysbee master
dannysbee master Joined: Nov 2003 Posts: 5,160 Texas	The melting point of brass is 1700 degrees, aluminum is 1200 degrees. Getting old just means you were smarter than some and luckier than others.

Entire Thread
Subject	Posted By	Posted
Brazing an exhaust port on an iron head	domingo	08/19/11 05:09 PM
Re: Brazing an exhaust port on an iron head	S/ST 3040	08/19/11 05:17 PM
Re: Brazing an exhaust port on an iron head	domingo	08/19/11 05:27 PM
Re: Brazing an exhaust port on an iron head	DJVCuda	08/19/11 05:28 PM
Re: Brazing an exhaust port on an iron head	domingo	08/19/11 06:16 PM
Re: Brazing an exhaust port on an iron head	Hemi Allstate	08/19/11 06:34 PM
Re: Brazing an exhaust port on an iron head	domingo	08/19/11 09:17 PM
Re: Brazing an exhaust port on an iron head	POS Dakota	08/19/11 09:40 PM
Re: Brazing an exhaust port on an iron head	dannysbee	08/19/11 10:06 PM
Re: Brazing an exhaust port on an iron head	Hemi Allstate	08/20/11 03:45 PM
Re: Brazing an exhaust port on an iron head	domingo	08/20/11 04:11 PM
Re: Brazing an exhaust port on an iron head	HEMIFRED	08/21/11 04:52 PM
Re: Brazing an exhaust port on an iron head	MR_P_BODY	08/19/11 07:54 PM
Re: Brazing an exhaust port on an iron head	dogdays	08/19/11 08:46 PM
Re: Brazing an exhaust port on an iron head	torkrules	08/21/11 01:25 PM
Re: Brazing an exhaust port on an iron head	70Cuda383	08/21/11 03:45 PM
Re: Brazing an exhaust port on an iron head	justinp61	08/21/11 04:09 PM
Re: Brazing an exhaust port on an iron head	MR_P_BODY	08/21/11 04:17 PM
Re: Brazing an exhaust port on an iron head	Mike Swann	08/21/11 04:30 PM

Hop To