Quote:

---

I by-pass mine with the pertronix points conversion and their flame thrower coil,it has its own resister built in to it

the pertronix conversion needs the full 12 volts to work correctly.

been like that for 15+ yrs now

---

My

If you are running a "full" MSD system fallow there recommendations they put there systems together to run that way.

I opted to run MP Orange Box conversion kit on my tbi swap and wanted to eliminate the BR so I looked into Blaster2 and as stated it a .8 ohm and scrachen recommended the Pertronix Flame-Thrower so I looked it up. Internally regulated, 1.5 ohm with 40,000 volts.

Now my Mopar engines 9th edition says I need 1.25 min. I bought the Part#40011 Flam-Thrower.

The instructions in the box say "1.5 Ohm Coils 8 cyl all applications Remove resistor."

It's up to you but the math adds up for me but look at your system and deiced for yourself because as you can see there are ALLOT of different opinions on this subject and only a little research along with trial and error will tell.

Just my good luck