|
Re: 727 opinions needed!
[Re: PJM]
#855448
11/16/10 07:31 PM
11/16/10 07:31 PM
|
Joined: Jan 2003
Posts: 25,817 Rio Linda, CA
John_Kunkel
Too Many Posts
|
Too Many Posts
Joined: Jan 2003
Posts: 25,817
Rio Linda, CA
|
Linkage or cable kickdown?
If linkage, does the aftermarket carburetor have the correct Mopar throttle lever extension?
The INTERNET, the MISinformation superhighway
|
|
|
Re: 727 opinions needed!
[Re: PJM]
#855452
11/17/10 10:57 AM
11/17/10 10:57 AM
|
Joined: Jan 2003
Posts: 75,020 U.S.S.A.
JohnRR
I Win
|
I Win
Joined: Jan 2003
Posts: 75,020
U.S.S.A.
|
Quote:
Thanks will give it a try
What about this question you failed to answer? What you want to do can still be affected by this.
Quote:
Linkage or cable kickdown?
If linkage, does the aftermarket carburetor have the correct Mopar throttle lever extension?
|
|
|
Re: 727 opinions needed!
[Re: PJM]
#855454
11/17/10 05:28 PM
11/17/10 05:28 PM
|
Joined: Jan 2003
Posts: 25,817 Rio Linda, CA
John_Kunkel
Too Many Posts
|
Too Many Posts
Joined: Jan 2003
Posts: 25,817
Rio Linda, CA
|
The Lokar only works properly if the travel of the carburetor lever matches the travel of the transmission lever, they are usually not the same.
Redrilling the hole on the transmission lever will most likely allow you to adjust the light throttle shift points without any governor mods.
The INTERNET, the MISinformation superhighway
|
|
|
Re: 727 opinions needed!
[Re: PJM]
#855456
11/17/10 05:53 PM
11/17/10 05:53 PM
|
Joined: Jan 2003
Posts: 75,020 U.S.S.A.
JohnRR
I Win
|
I Win
Joined: Jan 2003
Posts: 75,020
U.S.S.A.
|
Quote:
Would it not do the same by adjusting some slack in the cable? Right now it moves right when the throttle moves.
No, the Lokar is not setup properly for the application it is sold for.
The cable setup sold by Bouchillon is the better/correct setup to use .
|
|
|
Re: 727 opinions needed!
[Re: John_Kunkel]
#855458
11/17/10 06:18 PM
11/17/10 06:18 PM
|
Joined: Jun 2008
Posts: 213 florida
PJM
OP
enthusiast
|
OP
enthusiast
Joined: Jun 2008
Posts: 213
florida
|
Quote:
The Lokar only works properly if the travel of the carburetor lever matches the travel of the transmission lever, they are usually not the same.
Redrilling the hole on the transmission lever will most likely allow you to adjust the light throttle shift points without any governor mods.
If I understand you correctly it would be like choking up on a bat? Do you know the proper measurements for the travel? Thanks,
|
|
|
|
|
|