I need help finding a set of headers that will fit a 1965 Dodge Coronet with a 440? I have a set of Headman Elite Headers and they are nice but they rub on the drivers side torsion bar. Need a recommendation for a set that has good clearance, TTI or Dougs Headers?

Clint

dougs headers are great. good fit, no dinging required, coating looks great,too. i was pleased.

I'm using TTI's. The first set of headers I've ever installed that didn't require any tube denting.

i have tti`s on mine they fit great. if you want 3" exhaust pipes you will have to notch the trans cross member.

What type of header did you go with? Did you use a long tube or a fenderwell header?

Clint

I ran TTI 2" underchassis headers on my 65 Coronet wagon with a 440/stock heads and also 470/400 stroker/Indy heads. Fit perfect on both engines with no issues whatsoever. Great headers.

I have TTI's and they fit very well, the only complaint I have is that they wanted more for them plain than with the stupid chrome plating, I would have much preferred ceramic but like everything else today, we are only the stupid consumer, customer service is gone, gone, gone.
Joey

Are your headers fenderwell or under chassis?

Clint

mine are under chassis

I have some cheap Headmans on my 64 with a 440. They actually fit well with no dinging. Clears power steering. The collecter flange could be thicker but you get what you pay for. These were free.

Anyone have experience with the Headman's and a low deck in an early B?

These were on a 383 that was in the car. The clearance should be better than with a r/b. No starter clearance issues either.

I'm running them in a 64 Polara with a 383,no problems. They would hit a small MP starter when I had them in a 63 Plym. with a 440. Ok with stock starter.

2" tti's here. pefect fit.