Im building a 63 plymouth into a max wedge clone and wondering if anyone can help with the location of the two holes that need to be in the hood under the scoop. Also the location of how far the rear of the scoop should be from the back of the hood. I need the size of the holes and the location and would appriciate greatly any help. Thanks Guys! Without moparts and its vast knowledge what would our mopars look like?

Maybe this will help?

That definatly gives me an awsome idea what it will look like! Thanks but any measurements?

I would do it this way -> http://www.moparmax.com/tech/2007/ii_12-string-1.html ...if you want the holes right above the carbs. If you are using later model K-member or "different" motor mounts, the original holes would not probably match anyway.

For the hole centers I always install some 1/4" all-thread in the carbs just long enough to touch the inside of the hood when closed (grind the top to a point) and gently close the hood on the pointed end. Smack the top of the hood with your fist to leave a couple of dimples in the paint and that's center.

There's a Steve Magnante article on moparmax.com explaining how he did it on an AWB Dart build, if you can find it. I found the rest of the article, but not that part. It's described in his "how to build AWB cars" book too.