A little bit. I oredered the cam, carb, hat, and meth injection from Morris a few weeks ago, still wating on the meth kit. The cam should be showing up at the engine builder this week or next. He ordered the top end last week from Indy. He's waiting on the pistons and dampner so he can balance the rotating assembly. I've been working on my car quite a bit but its all little stuff, mounting the fuel pump, figuring out where I want to run the lines, mounted a trans cooler in the rear of the car, made a new support that goes from the hood latch down to just below the rad. Trying to figure out how to get the electronics placed inside and wired to look decent. Sent my procharger in to Procharger and had them go trough it and make sure everything is good, mostly for piece of mind. Got the rad mounted and more cage put in the car, it'll cert to 8.50 now.