Use white lithium greese to hold the fuel pump push rod in place while reattaching the fuel pump.

Spray the headliner with clean water then use a hair dryer to get the last few wrinkles out.

When installing wheel studs use several large thick washers and turn lugnut (installed backwards) slowly and wait a while to let it cool before continueing. 1/2 turn take a break 1/2 turn take a break etc.

Always put a nut on a shaft to tap it with a hammer to preserve threads.

To cut a bolt or threraded rod take two pieces of wood put rod between wood and clamp hard in vice. Prior to cutting run a nut past the cut line. Make the cut remove nut to clean up ouside threads.

On extremely hard to get at busted off studs, bolts, etc. get an explosives expert to POP it out.

To make a long run of two wires put them in drill stretch them out and run the drill the amount of twist is determined by the length of time the drill is run.

Had one guy that only liked to use one jumper cable he would touch the bumpers of the cars to be jumped then just use the positive cable.

Use a bright light in a dark garage to see leaks in floor boards, plugs, etc.

Having trouble finding a rattle drive down bumpy road with a friend driving and look for rattle.

gary