Ok update. I bought a new 1/2" drill and used it to prime the engine. Immediately the pressure on my high pressure oil pump went up to about 75 PSI. Then I turned the crank to 0 and the oil flowed out all over the rockers on the #2 side of the block, but I couldn't get the crank turned in the right spot to oil the #1 side of the engine. What's the science of turning this crank so I can both sides oiled now? How long does it need to turn once the oil flows out of the rockers? I mean as soon as I had it on the right spot it was just pouring out the rockers.
Once I do this pre-oiling I'm going to put my intake on. I have MS 96007 valley pan from Fel-Pro. I was checking at work today and it told me I needed another gasket set MS 90175 fiber port gaskets and it said must be used with valley pan MS 96007. All the books I'm referring to just show a valley pan and no paper gaskets being installed. Do I need to install these paper gaskets on the valley pan or leave them off?
