Quote:

If the crank in the 360 is drilled for the pilot bushing then it should work.

Not sure about the 87's but usually 360's are externally balanced so I doubt the 318 flywhhel will work. I could be wrong though.




Ok Like I said I'm new at this manual transmission thing, always autos. So whats the pilot bushing and how do I know if the crank is drilled for it or not? Time to go pick up a manual tranny book!!!!If the crank has a hole in the center rear its good or are there different sizes. Also if its not drilled for it, then is the crank just solid in the rear?


So the crank has to be drilled for the pilot bushing and I would have to pick up a new externally ballanced flywheel for a 360, will my clutch setup work or is that going to be different from 318-360?

Thanks

Butch

1972 Duster 318 4 speed 1958 392 Hemi engine waiting to be built!!!!!