Run Stand - Starter set up - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Run Stand - Starter set up

Print Thread

Re: Run Stand - Starter set up [Re: clovis] #3182707 10/10/23 11:34 AM 10/10/23 11:34 AM
Joined: Jan 2012 Posts: 2,678 Stuttgart, Arkansas rickseeman master
rickseeman master Joined: Jan 2012 Posts: 2,678 Stuttgart, Arkansas	I'm no expert on this but I just went through this on my test stand. (Mine is big block.) I had a 143 tooth flywheel and a 10-1/2" bellhousing but that flywheel is for a 11" clutch. (I think they use the same starter.) So I got a 10-1/2" flywheel. That worked with my bellhousing. 2011 Drag Pak Challenger

Entire Thread
Subject	Posted By	Posted
Run Stand - Starter set up	clovis	10/10/23 11:23 AM
Re: Run Stand - Starter set up	B1duster	10/10/23 02:34 PM
Re: Run Stand - Starter set up	clovis	10/10/23 03:01 PM
Re: Run Stand - Starter set up	rickseeman	10/10/23 03:34 PM
Re: Run Stand - Starter set up	Hemi_Joel	10/12/23 01:04 AM
Re: Run Stand - Starter set up	moparx	10/12/23 06:32 PM
Re: Run Stand - Starter set up	clovis	10/12/23 08:40 PM
Re: Run Stand - Starter set up	Cab_Burge	10/13/23 01:42 AM
Re: Run Stand - Starter set up	clovis	10/13/23 06:39 PM
Re: Run Stand - Starter set up	BANDIT	10/13/23 07:30 PM
Re: Run Stand - Starter set up	Hemi_Joel	10/13/23 08:51 PM
Re: Run Stand - Starter set up	moparx	10/14/23 05:53 PM
Re: Run Stand - Starter set up	Cab_Burge	10/15/23 07:35 AM
Re: Run Stand - Starter set up	clovis	11/10/23 04:48 AM
Re: Run Stand - Starter set up	BANDIT	11/12/23 06:45 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1