So I need to "hide" - or cleanly mount/route the following: -- Electronic ignition box -- Windshield washer reservoir (need ideas for container) -- Heater hoses -- Water temp sensor line
I would mount the ign under the dash. I ran all my wires for ignition/alternator down the passenger side frame rail, then have the harness coming across at the alternator. But I have a bit more room down there without the mech fuel pump. I would fab the heater lines out of SS tubing and also route them along the frame rail.
I would almost be tempted to mount/route everything out of the way, then make a cover, paint it, and no one will no the difference.
I don't mind seeing the inner workings, but this is cleaned up a bit compared to stock.
and I'd totally keep the DC valve covers!
I love the way you did your heater hoses! Thanks for all these ideas, I'll keep them in mind as I fab!