Quote:
So I need to "hide" - or cleanly mount/route the following: -- Electronic ignition box -- Windshield washer reservoir (need ideas for container) -- Heater hoses -- Water temp sensor line
I have always toyed with the idea of using an old speaker-mount rear window defroster for the windshield...but that is neither here nor there.
I would mount the ign under the dash. I ran all my wires for ignition/alternator down the passenger side frame rail, then have the harness coming across at the alternator. But I have a bit more room down there without the mech fuel pump. I would fab the heater lines out of SS tubing and also route them along the frame rail.
You could fab a small reservoir for the washer fluid, but I am not sure there is a clever way to hide the plumbing up to the cowl.
The problem with hiding everything, is it makes it a nightmare to work on. I would almost be tempted to mount/route everything out of the way, then make a cover, paint it, and no one will no the difference.
I don't mind seeing the inner workings, but this is cleaned up a bit compared to stock.
and I'd totally keep the DC valve covers!
Faster, Faster until the thrill of speed overcomes the fear of death...
71 Swinger - slowly collecting dust/parts 66 Belv. II - just a streetcar 88 Mustang - turbo LS beater
|