Quote:

What will you gain by centering the roller contact?
You have added the roller, that will greatly reduce the side-load on the valve stem and save the guide.
Put it together, race it and have fun.




I agree, especially given the extra large roller on the HS rockers.

I just ran into the exact same issue with my HS rockers on my Edelbrock heads, although mine seem to be slightly closer to center

But even if you went with lash caps, the recessed valve locks and lash caps would run about $80 plus pushrods, which is a lot less than a new set of good rockers.

'68 Bee 383/TF/Factory Air...high school sweetheart
'67 GTX Clone project,500 six pack,Hemi4-speed,Dana
05 Dodge Viper, 505 V-10, 6-speed Tremec