My issue with the Crower when I used it before was lack of low end, but that was with stock stroke, so I am on the fence, but if I can find it down at the shop, it sounds like with the added cubes, its good to go. This motor was over +700hp, and I would like to keep what I had, but obviously, I will loose a little.

As far as cross rams go, not on a '70 Cuda...Not to mention they make less hp than a single plane. A Modman and a tented top plate I could go for...

Mr-P, your thinking another .05" lift? I will look and see what's out there.

Anyone with a link to roller lifter with push rod oiling? I know I can get AMC solid flat tappet lifters with oiling, not sure about rollers.

Last edited by Dragula; 03/11/12 09:26 PM.
'70 Cuda,...605 EFI Hemi Street Car (6.20 best pass, 1.33 60ft)
https://www.youtube.com/watch?v=WYw6RA-k5Bk (6.25 at 108.75mph from inside car)
https://www.youtube.com/watch?v=3zQEb9uxFng (6.25 at 108mph from outside car)
https://www.youtube.com/watch?v=JCvfzsC4NgM (9.9)

'66 Barracuda AWB Stretched nose Blown 440 Car in build stage

'71 Duster Drag Car 400 Low Deck 512 best 6.002 at 115.44mph
https://www.youtube.com/watch?v=Znuo3jMUXTk