Quote: you need to flip the u-shaped bellcrank piece around so it is supported by both holes in the bracket.
i would if i could, but it wouldnt reach the stud when i had the bell crank u-shaped piece in the proper spot. tried it both ways. that stud is so far out to the side that this was the only way i could get it to line up. everything moves smoothly though.
Quote: you need to slide the slot in the rod to the other end of the gap you have to start with. as it is it is adjusted all the way out.
the rod is all the way out the way it is now when the throttle is closed.
Quote: may have to do some mods to it to get it to fit better,it gonna be weak with just the one end in the one hole on the bracket.
once the flat peice that goes to the stud is in place, it actually straightens things up pretty well and takes some of the slop out of not having the u shaped bell crank hooked into both holes.
maybe if i could take a quick video of it moving and send it to you somehow? maybe i'll put it on you tube...
