Cam motion and Comp have built me close to a dozen roller cams. I have just walked into cam motions store and watched them build me my cams years ago. I had some old cam building programs years ago and went experimenting at one time. Designs have changed since I did this. I am just unsure about 1.7 rockers and such. I would end up renting a dyno room for a day and trying different designs out.

A friend of mine has a superflow dyno just setting around not being used and not even hooked up. I had considered offering to buy it off of him. I was looking at it over the turkey hoiday.

But you are right about listening to everyones suggestions on cams. I have around 3 left, but I am thinking they were all 4.80 lobe lifts and up.