|
Re: Aerospace mandrel snafu
[Re: birdtracker]
#2930315
06/05/21 04:13 PM
06/05/21 04:13 PM
|
Joined: Dec 2012
Posts: 1,824 Wind Gap,Pa.
Sammy
top fuel
|
top fuel
Joined: Dec 2012
Posts: 1,824
Wind Gap,Pa.
|
my wife says I am hard headed. I even thought about milling flats on the end cap so a 12 point socket would go on. Birdtracker That bolt isn't even grade 8. I'm sure too much torque and you'll snap it, right off.
|
|
|
Re: Aerospace mandrel snafu
[Re: Sammy]
#2930325
06/05/21 05:31 PM
06/05/21 05:31 PM
|
Joined: Jun 2004
Posts: 926
birdtracker
OP
super stock
|
OP
super stock
Joined: Jun 2004
Posts: 926
|
my wife says I am hard headed. I even thought about milling flats on the end cap so a 12 point socket would go on. Birdtracker That bolt isn't even grade 8. I'm sure too much torque and you'll snap it, right off. exactly. Thought maybe someone came up with something that worked better. Birdtracker
|
|
|
Re: Aerospace mandrel snafu
[Re: birdtracker]
#2930427
06/06/21 12:19 AM
06/06/21 12:19 AM
|
Joined: Jul 2008
Posts: 610 Boise
Moparteacher
mopar
|
mopar
Joined: Jul 2008
Posts: 610
Boise
|
Several manufacturers make a hex nut for 1' and 1.125: crank mandrels. Look at Jones Racing.
CS-6103-A for 1.125" mandrel. CS-6103-B for 1" mandrel.
Last edited by Moparteacher; 06/06/21 12:25 AM.
|
|
|
Re: Aerospace mandrel snafu
[Re: Moparteacher]
#2930429
06/06/21 01:47 AM
06/06/21 01:47 AM
|
Joined: Oct 2006
Posts: 1,264 New York, USA
Chargerfan68
pro stock
|
pro stock
Joined: Oct 2006
Posts: 1,264
New York, USA
|
Several manufacturers make a hex nut for 1' and 1.125: crank mandrels. Look at Jones Racing.
CS-6103-A for 1.125" mandrel. CS-6103-B for 1" mandrel. Yes, jones racing.
1.50 60Ft. , 10.75@ 127MPH Hauling 3900 LBS.
|
|
|
|
|
|