|
|
distributor ID please
#2818601
09/08/20 03:28 PM
09/08/20 03:28 PM
|
Joined: Feb 2007
Posts: 1,668
Caldwell, Idaho
67R/T4speeder
OP
top fuel
|
OP
top fuel
Joined: Feb 2007
Posts: 1,668
Caldwell, Idaho
|
No tag
Stamped, # On Iron housing is IBP 1A
# on advance 3438262
Single points
Thanks
Last edited by 67R/T4speeder; 09/08/20 03:47 PM.
|
|
|
Re: distributor ID please
[Re: mopars4ever]
#2818647
09/08/20 05:04 PM
09/08/20 05:04 PM
|
Joined: Jan 2003
Posts: 25,767
Rio Linda, CA
John_Kunkel
Too Many Posts
|
Too Many Posts
Joined: Jan 2003
Posts: 25,767
Rio Linda, CA
|
The vacuum advance fits many '69-'71 383/440 emissions distributors. Measure the shaft to find which one.
383 – 3.5"
440– 4.0"
The INTERNET, the MISinformation superhighway
|
|
|
Re: distributor ID please
[Re: John_Kunkel]
#2818654
09/08/20 05:13 PM
09/08/20 05:13 PM
|
Joined: Feb 2007
Posts: 1,668
Caldwell, Idaho
67R/T4speeder
OP
top fuel
|
OP
top fuel
Joined: Feb 2007
Posts: 1,668
Caldwell, Idaho
|
The vacuum advance fits many '69-'71 383/440 emissions distributors. Measure the shaft to find which one.
383 – 3.5"
440– 4.0" 440 Then Thanks
|
|
|
Re: distributor ID please
[Re: dragon slayer]
#2818850
09/09/20 09:38 AM
09/09/20 09:38 AM
|
Joined: Jan 2003
Posts: 9,436
Blair County,PA
62maxwgn
master
|
master
Joined: Jan 2003
Posts: 9,436
Blair County,PA
|
Some one may have swapped that vacuum adv on it. I think it is the odd ball from mid 60s. Kind of a Chrysler duplication of a Prestolite. Notice the clips for holding cap on. They are different. Basically using a Chrysler cap/rotor on the prestolite type cast iron body. The ones I have seen have been single point.
Rebuilt one a while ago, thought it was a 24xxxxx number, but not completely sure. Also has a nylon shaft retainer that was not used on the Prestolite,and a riveted clip retainer used on the early distributors. .
|
|
|
|
|
|
|
