|
Re: 8 1/4 changing axle bearings and seals
[Re: 5thAve]
#2764128
04/15/20 09:01 AM
04/15/20 09:01 AM
|
Joined: Nov 2004
Posts: 25,050 Texas
GoodysGotaCuda
5.7L Hemi, 6spd
|
5.7L Hemi, 6spd
Joined: Nov 2004
Posts: 25,050
Texas
|
Is there any special tools or tricks to do this job? I'm getting ready to install an 8 1/4 that's been sitting outdoors for a while. Somewhat protected from the weather. I figure since I'm cleaning it up and swapping my own backing plates onto it anyway I might as well do this too. Thanks You'll want a slide hammer to get the bearings out of the housing.
|
|
|
Re: 8 1/4 changing axle bearings and seals
[Re: GoodysGotaCuda]
#2764187
04/15/20 11:15 AM
04/15/20 11:15 AM
|
Joined: Jan 2003
Posts: 1,604 westerly, ri. usa
440lebaron
top fuel
|
top fuel
Joined: Jan 2003
Posts: 1,604
westerly, ri. usa
|
you can easily pop/pry the seal out with the end of the axle
all parts are sold as is, all parts are considered used no warranties or returns paypal/check/money order, shipping is from zip 02891, buyer pays paypal fees 24% IRS 1099A plus 3% of part price, check/money order preferred site is not monitored 24/7 there might be a delay in response
|
|
|
Re: 8 1/4 changing axle bearings and seals
[Re: 440lebaron]
#2764211
04/15/20 12:12 PM
04/15/20 12:12 PM
|
Joined: Jan 2003
Posts: 3,122 Auburn WA
Dave_J
master
|
master
Joined: Jan 2003
Posts: 3,122
Auburn WA
|
Both of those above. You need a seal puller to pop the seal out of the axle tube to get to the pressed in bearing. Then a slice hammer with a bearing grab fork doohicky. I've done about 10 over the years on jack stands and no special tools.
Retired, US ARMY 1973-1994 ASE mechanic, Electrical 1994-1997 Retired GTE/VERIZON/FRONTIER 1997-2015
Posting cheap tech help (CRAP) here since Nov 97, 1000's of posts, some may be good.
03 Suzuki Burgman 650(Burger King) Scooter 65 Formula S Cuda 78 Little Red Express Truck 98 Buick Regal (wifes car)
|
|
|
|
|
|