It turns out there was no collision on my trailer, no fault in MI. So I get $1000 from the girls insurance on a mini-tort. I figure how hard can it be. It's like a roll cage, albeit a bent one. The floor came out pretty easy. Took a 100 mile round trip down to Jerry Lozon's and got some info and the parts. Jerry is a great guy, very helpful. Yesterday I stripped the door. Man is it heavy. When you remove the diamond plate and the 3/4" plywood it comes up by itself, FAST. Then torched out the rear cross member and trimmed the welds with the cut off wheel. Today I cut the door frame apart. Dollied out the bent center and made a jig to square it up. The uprights were pulled in 2" at the bottom. Got it all welded up. Had to borrow a port-a-power to spread the uprights at the latch as the were bowed 3/8". Tomorrow I'll tackle the new cross member after work.
Doug

After the cut. Bent tie down support. Got it beat back to straight.

The door frame damage.

OUCH!!!

Man that really sucks ------ I'm sure you will get it fixed and done right though.


So your insurance would not cover the damage? I'm going to have to check into mine but think I have mine covered in a case like you had.

The door frame cut. The door frame jigged up.

door frame done.

In New York the no fault applies to medical coverage. Liability % still applies.
Either way your doing a good job!

When you get it done, it will be nicer than it was when it was new ..

Thats BS on the no fault crap

If your in a no fault state you special coverage on your trailer. I have mine covered. Looks good your doing your usual great work.

Progress continues. Got the rear cross member fitted and welded in. Figured out the geometry of the hinges since they were larger in diameter. After welding the hinges to the door it bowed in 1/2" at the bottom. Put a 4x4 under the center and 3 of us jumped on it, perfect. Set the door and got everything welded up.
Doug

For $35.00 a year you could have it insured for $5000.00

Looks nice!

Once again I'm reminded that everyone in the world has way more skills than I do. It's going to be better than new soon!

I guess I missed a previous thread, Doug. When did this happen? The repair job looks great.

Dennis

nice job

3 Fridays ago on the way to Milan. Got it all painted tonight. Ready to reskin starting tomorrow.
Doug

Got the frame painted, trim straightened (best I could) and the door is done. Even changed out the LR last side panel. Still have to finish the floor, change out the RS side panel and the rear taillight trim.
Doug

Nice work there doug. I thought for sure that was you I saw going to Milan sunday there was a rig just like yours heading out but when I got there it wasn't you. I was looking forward to see you as we were there testing 2 cars. So I had my hands full. So I take it you haven't tried that other set up on your car yet???

Looks good you do nice work.
Any chance you'll have it done for this weekend?
DD reunion @ Milan?

Gary