|
Re: Super Stealth heads
[Re: JohnRR]
#1108211
11/06/11 11:07 PM
11/06/11 11:07 PM
|
Joined: Aug 2006
Posts: 2,141 junction city oregon
viperblue72
OP
top fuel
|
OP
top fuel
Joined: Aug 2006
Posts: 2,141
junction city oregon
|
Quote:
Quote:
maybe the best flowing, stock length valve cylinder head,
Can you elaborate on that since no flow numbers were given and they have to be finished ???
If he could have elaborated he wouldn't have said "maybe". But you are correct that Brandon was a little vague about a few of the specifics. No intake volume size either but he did say not quite a max wedge size. and valves seats are 2.14x1.81 iirc. Chambers are same as standard stealths at 80cc.
|
|
|
Re: Super Stealth heads
[Re: viperblue72]
#1108212
11/06/11 11:09 PM
11/06/11 11:09 PM
|
Joined: Aug 2006
Posts: 2,141 junction city oregon
viperblue72
OP
top fuel
|
OP
top fuel
Joined: Aug 2006
Posts: 2,141
junction city oregon
|
Quote:
Quote:
Quote:
maybe the best flowing, stock length valve cylinder head,
Can you elaborate on that since no flow numbers were given and they have to be finished ???
If he could have elaborated he wouldn't have said "maybe", but being there aren't any other aftermarket factory appearing heads out there he is probably right. But you are correct that Brandon was a little vague about a few of the specifics. No intake volume size either but he did say not quite a max wedge size. and valves seats are 2.14x1.81 iirc. Chambers are same as standard stealths at 80cc.
|
|
|
Re: Super Stealth heads
[Re: JohnRR]
#1108213
11/06/11 11:16 PM
11/06/11 11:16 PM
|
Joined: Dec 2004
Posts: 915 S.W. PA
6PACMAC
super stock
|
super stock
Joined: Dec 2004
Posts: 915
S.W. PA
|
Quote:
Quote:
maybe the best flowing, stock length valve cylinder head,
Can you elaborate on that since no flow numbers were given and they have to be finished ???
The key word is "maybe".
|
|
|
Re: Super Stealth heads
[Re: 6PACMAC]
#1108215
11/07/11 07:49 PM
11/07/11 07:49 PM
|
Joined: Jan 2003
Posts: 15,439 Val-haul-ass... eventually
BradH
Taking time off to work on my car
|
Taking time off to work on my car
Joined: Jan 2003
Posts: 15,439
Val-haul-ass... eventually
|
Quote:
Man the casting really look super thin around the pushrod hole.
Too thin for my taste. Those things better come w/ the phone number of your closest qualified aluminum welder.
|
|
|
|
|
|