just a few pictures from last weeks project. Im really happy with the results, Thats an NOS trim ring thanks to Cudablues (Thanks Gary!)

I didnt quite get the overspray pattern correct on the between-side...you know between the front and back (I dont know the technical term for this part of the rim! )I was more concerned with getting the metallic to lay nice on the face.

let me know what you think....I can take critisism, a little anyway.

before:

AFTER:

Very nice work...

Dunno what the others will say but I say they look prett sweet! Nice job! Did you rattle can the silver on the wheel or use a gun?

Joe

You can do mine. They look great.

You didn't duplicate the overspray pattern on the inside of the wheel .

I used PPG paint through my gun.

John, by "the inside of the wheel" do you mean the back side that bolts against the drums/spindles? If thats the area youre referring to then I got pretty close in that area. I didnt mask off the wheel and just let the silver flow through the holes.
I didnt post that pic because I didnt think anyone would care and the overspray is hard to see, just looks like a bad pic.

You are more than welcome Dave,least i could do for what you went thru shipping the motor Gary

are all 14" '70 Challenger wheels like those the same size even if the car was a /6?

thats easily a one day job. lots of work and taping off the center caps is a lot of fun too?? lol..... Did you use Frank B's centercap paint. The spray gun is so much better on a project like this. Nice job and make sure you find a tire shop with a mounting machine that wont damage your work.