Quote:

IF you waant it to look like a butcher job either:
A. loop the larger heater hose
B. cut and cap them

If you want to do it right:
heat the ends with a torch clamp on the vise grips and unscrew.
then get the proper plugs for a nice clean install.




Thanks Stupify.

What are the heating of the ends for? Also, this may be a dumb question .. but what is a torch clamp? I do have vise-grips....so at least I'm covered there

As for getting the proper plugs -- anyone know the right size I need to look for for a '70 440 motor?

Thanks everyone! I continue to learn great things everyday on this board!