To make sure we are on the same page, there are really 2? kinds of CF, the real high tech CF high temp oven baked vacum bag F1 stuff, and the typical resin/epoxy CF cloth reinforced matrix. I think you are talking cost wise about the latter. It is not to tough to do, and after a visit to AAR Fiberglass in Melborne, Fla, the owner years ago said he would do CF on any of his existing molds at an upcharge. However, there is not a great deal of weight savings, only more cost, increased flash factor, tougher to repair, with some increase in stiffness, allowing some/slight reduction in thickness. The F1 stuff is what you want, but can't get,


Reality check, that half the population is smarter then 50% of the people and it's a constantly contested fact.