Quote:

Quote:

Quote:

I called up Milodon today and they said my pan might not have been cut deep enough for the seal and to send it back to summit for an exchange. I asked if it was a common issue and he said no.

I'm going to exchange it but it still doesn't explain why the seal doesn't fit correctly on my block. Mines a magnum 5.9 but it should fit the same as a LA block.




I think you need to investigate that further. Search Moparts. I know it's been discussed before. AndyF was the last person I saw that brought it up.

Next time I see Milodon, I bring it up.




Hi Steve, not to high jack this thread but I PMed you concerning a 340 car. Thanks.




Yeah I mean I dont seem to know what the issue is as lots of people are running magnum motors with la oil pans.

I've done a lot of searching but as much as I love moparts, the search engine isn't very good compared to some forums. I'll try again though.

Worst case scenario I think I'll end up trimming the gasket. The guy I spoke with at Milodon recommended that over just using RTV

Last edited by chache876; 05/15/10 09:28 PM.