Quote:

As I launched, this broke. 1.40 60ft in a 2800lb truck in this heat. This is a OEM pc with spicer 7260 u-joints. All the u-joints look and feel fine. The drive line angle at the front u-joint is about 2 degress off but I would think the u-joint would have failed if that was a facor.
It also took out the tail housing of the trans. I'll have to pull the trans and check the sprag and the output shaft.
When it hit the drive shaft loop, it put some dings in the drive shaft so I will build a new drive shaft.
What should I do? Build a drive shaft with 1350s and billet yokes or use OEM parts? Thanks, Scott.



1.40 60 ft and you want to use OEM parts ??? NO

and correct your driveline angle