What diameter do you have on the dummy shaft? With that, I should be able to make a set
I just stopped by dealership #2 where I know the "old guy that's been there forever" and was pretty much told "not to worry about it"
This guy said he's done more of those tranny's than he can remember but hasn't done one in 10 years, but don't remember ever measuring those 2 things and "they always seemed to work".
I have a couple of these tranny's to redo, another RE and an older a500. Id like to at least see where they stand for comparison to both "the book" and to each other.
Measure your intermediate shaft at the two journals (should both be same diameter). The long shaft just aligns the splines inside the OD unit. If you had an old output shaft you could just cut the excess off at the top and use that.
