Trying to upload videos but i am unsuccessful nothing seems to get them to work.

My Brother (CopperDart) Ricky built the engine so he did the run in, other than the timing being a bit retarded on startup it went flawlessly, beer Engine never went above 190* the fans cycled perfectly only needed some temperature adjustments, 50 lbs of oil pressure at +/- 2000 rpm, after 30 minutes adjusted the idle down and the mixture screws a bit. Drove the truck a few miles and been pulling it in and out of the shop everyday without any hiccups. it is off to the alignment shop (HOPEFULLY SOON) i need my space back! whistling and my brothers lift to do the little things i wrote of a couple posts back.

Last edited by modelmakerinc; 01/02/24 11:16 AM.
Exceptional Architectural, Yacht and Automotive scale models. e-mail modelmakerinc@att.net for a portfolio review. www.modelmakerinc.com