How close is too close. - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech How close is too close.

Print Thread

How close is too close. #3046048 05/29/22 04:50 AM 05/29/22 04:50 AM
Joined: Dec 2006 Posts: 4,647 aotearoa rebel OP master
rebel OP master Joined: Dec 2006 Posts: 4,647 aotearoa	Im doing a rdbuild on a motor & was doing the plastercine sqwish test to confirm clearences, everything is fine except that intake valve is real close. The valve dips into the relief by 0.060, but the edge of ghe fave face only misses the valve pocket side wall by 0.045. Wohld you consider that too close? Maybe I should advance the cam half a degree? Whats your call?

Entire Thread
Subject	Posted By	Posted
How close is too close.	rebel	05/29/22 08:50 AM
Re: How close is too close.	moparacer	05/29/22 11:54 AM
Re: How close is too close.	DavidDean	05/29/22 02:04 PM
Re: How close is too close.	dvw	05/29/22 02:27 PM
Re: How close is too close.	440Jim	05/29/22 03:02 PM
Re: How close is too close.	Mr PotatoHead	05/29/22 05:44 PM
Re: How close is too close.	Stanton	05/29/22 10:46 PM
Re: How close is too close.	rebel	05/30/22 03:13 AM
Re: How close is too close.	INTMD8	05/30/22 04:07 AM
Re: How close is too close.	BigDaddy440	05/30/22 05:59 AM
Re: How close is too close.	rebel	05/30/22 10:56 AM
Re: How close is too close.	B1MAXX	05/30/22 12:08 PM
Re: How close is too close.	Cab_Burge	05/30/22 06:40 PM
Re: How close is too close.	HardcoreB	05/31/22 11:54 AM
Re: How close is too close.	340Cuda	05/29/22 05:28 PM
Re: How close is too close.	Cab_Burge	05/30/22 05:11 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1