I established ride height, wheel and tire combo plus stance so I was able to measure engine combo, radiator with fans and shroud.
This gave me engine position front to rear. I am well aware it will sit under /inside of cowl but the standard wheelbase, fenders and hood all will remain to factory specs..
This gives me a small window to fab the tranny mount.
I had Boling Brothers install their standard flange for SBC/Auto expecting to modify for Ma Mopars finest small block 727.
I am using a later style modified spool mount. Their mount flange is just a flat plate, i removed a center section for mount clearance and low transmission position.
Last edited by modelmakerinc; 05/03/22 02:55 PM.