Back story: I went on a short trip to purchase a pair of heads for my Dart. The seller had me surrounded by Hemi. 6 blocks, probably 20 sets of heads, rare stuff all around. So it got my interest up and I started to dive into a research tangent on Hemis. But I can't seem to find the information I am looking for. So I'll ask you.
If you were going to build a big inch street engine(572-605), would you go with an iron block or aluminum? Why? Hydraulic roller, solid roller?Street would entail lots of street miles, trips down the freeway, and possibly a weekly test and tune session here in the weather challenged states.
If you would need an application, let's shoot for 850 horsepower, broad torque curve, heavy car, clutch, 3.23-3.55 gear, likely overdrive.
Yes, this would be my dream build for my Super Bee, but I'm just daydreaming and bench racing. Most importantly, I'm still learning.