I fiddled with the wiring again. I can make the power turn off and on by pushing and pulling on the fusible link where it connects to BH connector block.
If this is just a loose terminal.....
The terminals are supposed to lock into the housings. Disconnect the bulk connector and look at the terminals inside the connectors. It's a little harder on the female terminal because it is buried behind the fuse block.
If the terminals are not all the way into the connector try to pull them out and expand the locking tabs. The locking tab on the male is that weird hook area between the tip and the crimp below the circle on the tip. I will expand them a little extra whenever I build a harness to make sure they lock into the connector.
