I’m beginning to think there’s a bad connection or I’m missing a ground somewhere.

The whole dash harness is factory. I replaced the harness inside the column including the Key switch and signal switch. I also replaced the harness for the neutral safety switch and the neutral safety switch itself.

The only thing I added in the start circuit are the wires at the bulkhead in the engine bay going to the coil and start terminal to the starter solenoid. The wire I have going from the “start” terminal at the bulkhead to “s” on my starting solenoid is wrong because the wire I have coming from the bulkhead at the “start” terminal should go to the coil. Right ?