Originally Posted by jlatessa
Thanks for the heads-up on the snout , Dave.

How did you check it, by feel, bluing or measuring?

Joe

I measured from the pump drive down to the inside of the pilot then pump drive down to ring gear then ring gear to pilot outside with the vert on a counter top.I think .020 was min spec.
ps;measure from the bolt lug to the top of the pilot with a straight edge on the vert for pilot ht.[about .625"]

Last edited by Clanton; 10/23/19 11:45 AM.
GOTBOOST!New improved with Victor heads.
http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/