The cr is a little low for that cam, and the stall is too low as well.

Don't assume anything on the cr. CC and measure everything so you know what you really have.

I've only run that cam in one 440 years ago when that series of cams first came out.
It went in a 6bbl build with mild ported big valve 906's, and had 9.2cr.
The valvetrain noise was as bad as a solid, and it was into valvetrain unhappiness at about 5600rpm(Isky 8005a dual springs, HS 1.5's).
I ended up taking it out as I wasn't too happy with the power either.
I swapped it out for a Crane H-302 instead, and in that particular motor, it did everything better.
Less noise, more tq/hp, revved a couple hundred rpm higher before the unhappiness set in too.